Eric: Created page with " switch1#sh ip route Gateway of last resort is not set 192.168.99.0/24 is variably subnetted, 2 subnets, 2 masks S 192.168.99.8/29 [1/0] via 192.168.99.2 C 192.168.99.0/30 is directly connected, GigabitEthernet1/0/28 C 192.168.32.0/24 is directly connected, GigabitEthernet1/0/1 switch1#sh ip int brief Interface IP-Address OK? Method Status Protocol GigabitEthernet1/0/1 192.168.32.3 YES manual up..."

2022-04-04T19:18:05Z

Created page with " switch1#sh ip route Gateway of last resort is not set 192.168.99.0/24 is variably subnetted, 2 subnets, 2 masks S 192.168.99.8/29 [1/0] via 192.168.99.2 C 192.168.99.0/30 is directly connected, GigabitEthernet1/0/28 C 192.168.32.0/24 is directly connected, GigabitEthernet1/0/1 switch1#sh ip int brief Interface IP-Address OK? Method Status Protocol GigabitEthernet1/0/1 192.168.32.3 YES manual up..."

New page

switch1#sh ip route
Gateway of last resort is not set
192.168.99.0/24 is variably subnetted, 2 subnets, 2 masks
S 192.168.99.8/29 [1/0] via 192.168.99.2
C 192.168.99.0/30 is directly connected, GigabitEthernet1/0/28
C 192.168.32.0/24 is directly connected, GigabitEthernet1/0/1

switch1#sh ip int brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet1/0/1 192.168.32.3 YES manual up up
GigabitEthernet1/0/28 192.168.99.1 YES manual up up

switch1#sh run int gi1/0/1
interface GigabitEthernet1/0/1
no switchport
ip address 192.168.32.3 255.255.255.0
spanning-tree portfast
end

switch1#sh run int gi1/0/28
interface GigabitEthernet1/0/28
no switchport
ip address 192.168.99.1 255.255.255.252
ip policy route-map test
end

switch1#sh run
ip access-list standard loop0
permit 192.168.99.10 log
permit 192.168.99.12
!
route-map test permit 10
match ip address loop0
set ip next-hop 192.168.32.1 ! default gateway van het 192.168.32.0/24 segment
!
route-map test permit 20
set ip next-hop 192.168.32.9 ! Niet bestaand ip, dus deze route werkt niet
!

----

switch2#sh ip route
Gateway of last resort is 192.168.99.1 to network 0.0.0.0

192.168.99.0/24 is variably subnetted, 4 subnets, 2 masks
C 192.168.99.11/32 is directly connected, Loopback1
C 192.168.99.10/32 is directly connected, Loopback0
C 192.168.99.12/32 is directly connected, Loopback2
C 192.168.99.0/30 is directly connected, GigabitEthernet1/0/28
S* 0.0.0.0/0 [1/0] via 192.168.99.1

switch2#sh ip int brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet1/0/28 192.168.99.2 YES manual up up
Loopback0 192.168.99.10 YES manual up up
Loopback1 192.168.99.11 YES manual up up
Loopback2 192.168.99.12 YES manual up up

switch2#sh run int gi1/0/28
interface GigabitEthernet1/0/28
no switchport
ip address 192.168.99.2 255.255.255.252
end

switch2#sh run int lo0
interface Loopback0
ip address 192.168.99.10 255.255.255.255
end

switch2#sh run int lo1
interface Loopback1
ip address 192.168.99.11 255.255.255.255
end

switch2#sh run int lo2
interface Loopback2
ip address 192.168.99.12 255.255.255.255
end

switch2#ping 1.1.1.1 source lo0

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
Packet sent with a source address of 192.168.99.10
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/4/9 ms

switch2#ping 1.1.1.1 source lo1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
Packet sent with a source address of 192.168.99.11
.....
Success rate is 0 percent (0/5)

switch2#ping 1.1.1.1 source lo2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
Packet sent with a source address of 192.168.99.12
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/9 ms

[[Category:Cisco Voorbeeldconfigs]][[Category:Cisco]][[Category:Netwerk]]

PBR - Revision history